
Installation GuideV1.1 April 2015High PerformanceInvisible LoudspeakerAIW750iProducts may vary from items pictured
Cavity installation with xing blockscontinued...0304Install speaker cable and insert insulationEnsure all speaker cables are pulled through to the sp
Cavity installation continued...0506Connect the Evolution Series speakerConnect the speaker cable to the speaker using a high quality crimping tool.Yo
For new builds or full refurbishment where sound transmission needs to be reduced or fire rating is required.0102Cavity installation with backboxCVLoc
Cavity installation with backboxCV continued...05Connect the speakerFollow step 05 on page 07Secure the speakerPosition the cable away from the rear o
02Solid wall installation with BackboxSWFor new builds or full refurbs 0102Create aperture in brickwork/ concreteUsing the combination of an angle gri
04Solid wall installation with backbox continued...0304Install backboxMake a small hole in one of the rubber grommets and pull the speaker cable throu
12Solid wall installation with Backbox continued...05Secure the speakerEnsure the speaker cable is laid behind themineral wool or natural fibre and ca
Top View05Solid wall installation with backboxcontinued...1 2Secure the speakerEnsure the speaker cable is laid behind the mineral wool and cannot res
14Retrot / pre-skimmed plasterboardFeathered skim nishFor walls /ceilings that have already been plaster finished.Speaker alignment required for pla
Retrot / pre-skimmed surfacesFull wet skim nishFor walls /ceilings that have already been plaster finished.Speaker alignment required for plastering
Continue to sectionRetrot drywallPatch plastered nishFor new drywall walls /ceilings that will be taped and jointed.(typically in North America but
Retrot drywallFeathered skim nishFor new drywall walls /ceilings that will be taped and jointed.(typically in North American but becoming common els
Testing the speakers>>>>>>>>>>>Important: Always test the speaker before plastering over it and again once plaster is
Plastering and decorating010203Fill gap between speaker and surrounding areaIt is important to ensure that plaster is pushed into the 2mm (5/64”) gap
Plastering and decorating continued...0405PlasteringUse standard low shrinkage finishing plaster for large areas. For patch plastering use a low shrin
Setup tips>>>>>>>>APU750iYour Evolution Series speaker must be used with the supplied APU750i protection device or another app
Setup tips>>>>>Speaker OrientationThe AIW750i can be installed either in portrait or landscape orientations but has been optimised for
Setup tips>>>>>>23 Boundary Loading It is possible to increase the low frequency output of the AIW750i by positioning them close (50
Further detailsMaintenance and cleaningOnce your AIW750i speaker is plastered into your wall or ceiling, it requires no physical maintenance. Your wal
Troubleshooting>>>>>Thorough testing of the speakers should be carried out both prior to and after plastering to avoid time consuming r
Ensure that all installation mounting surfaces are able to support the weight of the product.After installation, avoid pushing on the wall or ceiling
SpecicationsSpecications: APU750iModel NumberDimensions LF PanelDimensions HF PanelWeight (LF/HF)Nominal ImpedanceFrequency ResponseSensitivityConne
Spacesaver information0102Using the Cut out Template for pre-installStaple to plasterboard/ drywall to act as a template.Using the cut out template1.
Warranty informationLimited Warranty:The AIW750i speakers are designed to operate reliably for many years. Correctly installed in accordance with thes
APU750i Passive, in-line protection units for AIW750i speakers are available in 2-channel versions and in an 8-channel, 1U rack mountable version.AIW7
30Wiring SchematicSingle Pair ConnectionBi Wire ConnectionAMPL R+ -In Out In OutAPU 750iLFHFHF+ -+ -+ - + -+ -+ - + -- + - ++ -+ -LFAMPL R+ -In O
Amina Technologies Ltd Cirrus House, Glebe Road, HuntingdonCambridge, PE29 7DL, UKT: +44 (0) 1480 354390E: [email protected]: www.amina.co.ukNorth
01 Message from the Managing Director02 Included in the carton / Packaging03 How to use this manual04 Installation overview diagramSectionPreparin
Message from the Managing DirectorCongratulations and thank you for purchasing an Amina Technologies Evolution Series highperformance invisible loudsp
Included in the cartonPlease check that your carton contains the correct number of items.Model Number Single AIW750i 1x HF loudspeaker panel
How to use this manualThe following pages contain step by step advice to help you achieve a successful installation of your Evolution Series loudspeak
Installation overviewSectionSectionPreparing the wall / ceilingand fixing the productAlignment and plastering preparation in retrofit applicationsCavi
Cavity installationPreparing the wall/ceiling and xing the productTypically a new build or full refurbishment /Uses mounting blocks (sold separately)
Comentários a estes Manuais